[HELP] I broke my TX3 mini (S9012P) what to do now?

[Anan5a]

So I was impatient and did this

1. Copy img file and other 2 aml_* files and powertool.apk in SD card,
Then instead of booting and installing the APK I just foolishly pressed the reset button and connect power, and boom it no longer boots. The only light in the spdif port is on (red)

What can I do now?

(Blue pcb, 2+16gb, bought at least a year ago)

[em3ka]

Stock firmware .img, USB Burning Tool 2.1.7.3 and usb male to male cable...

https://youtu.be/liMLeHuweSQ

[Anan5a]

Stock firmware .img, USB Burning Tool 2.1.7.3 and usb male to male cable...

https://youtu.be/liMLeHuweSQ

Do I do it first or I can directly use the atvx image?

[em3ka]

You can use it directly, i would check revison of the board first !

[Anan5a]

You can use it directly, i would check revison of the board first !

I successfully flushed atvX 4.3 (using a hacked ( ) cable (didn't have an a-a nearby so I made one out of damaged card readers.

Edit:

WiFi doesn't work

But the status display in front not working. What to do?

[em3ka]

...But the status display in front not working.

Not supported.

Kudos on cable hack.

[Anan5a]

...But the status display in front not working.

Not supported.

Kudos on cable hack.

then how do get wifi working? I can't really connect Ethernet to it

[em3ka]

then how do get wifi working?

Which chip ?

[Anan5a]

then how do get wifi working?

Which chip ?

I don't know right now. But it's certainly not one of the chips that's supposed to work by default.

Can you provide instructions for all chips (except those in the *tested* list) and I'll try them on by one.

[em3ka]

I don't know right now. But it's certainly not one of the chips that's supposed to work by default...

Post the HQ photo of both sides of PCB.