Buenos días.
Adquirí actualmente un Magicsee N5 y lo primero que hice fue cambiar la rom stock (que es horrible por cierto) por la ATVxperience V2 adaptada al N5.
Va genial salvo una cosa. El control remoto. Funciona bien mientras está encendido pero cuando lo apago no puedo encenderlo con el control remoto. Debo quitar y poner el cable power.
Alguna solución por favor ???
Gracias
[ROM] Magicsee N5 - atvXperience v2 N5 Edition
-
- Administrator & Developer
- Posts: 1551
- Joined: Tue Oct 02, 2018 6:19 pm
- Has thanked: 211 times
- Been thanked: 334 times
From now on, posts without proper translation will be deleted without warning, have respect for the team and translate your texts into Englishkikko123 wrote: ↑Sat May 16, 2020 12:27 pm Buenos días.
Adquirí actualmente un Magicsee N5 y lo primero que hice fue cambiar la rom stock (que es horrible por cierto) por la ATVxperience V2 adaptada al N5.
Va genial salvo una cosa. El control remoto. Funciona bien mientras está encendido pero cuando lo apago no puedo encenderlo con el control remoto. Debo quitar y poner el cable power.
Alguna solución por favor ???
Gracias
thx
-
- Posts: 9
- Joined: Thu Nov 21, 2019 6:46 pm
Good Morning
I currently purchased a Magicsee N5 and the first thing I did was change the stock of rom (which is horrible by the way) for the ATVxperience V2 adapted to the N5.
It is great except for one thing. The remote control. It works fine while powered on but when I turn it off I can't turn it on with the remote. I must remove and put the power cord.
Any solution please?
Thank you
I currently purchased a Magicsee N5 and the first thing I did was change the stock of rom (which is horrible by the way) for the ATVxperience V2 adapted to the N5.
It is great except for one thing. The remote control. It works fine while powered on but when I turn it off I can't turn it on with the remote. I must remove and put the power cord.
Any solution please?
Thank you
- em3ka
- Moderator
- Posts: 1835
- Joined: Sun Jul 15, 2018 11:43 am
- Has thanked: 108 times
- Been thanked: 370 times
Everything, in principle, is standard. The procedure is important.vinitroiano wrote: ↑Tue May 26, 2020 2:18 pm ...i installed the rom, the USB Burning Tool no longer recognized my tv box...
1) Run the USB Burning Tool, select the original (or 100% working on this box) firmware. Click Start.
2) Clamp the reset on the box, apply external power through the power connector.
3) Short the 29th and 30th pins on NAND. In our boxing, this is the 5th and 6th pins after the triangle. Those. on the inductance side, marked 2R2.
4) Stick in the firmware cable. Boxing should be determined, and the firmware process should begin. Then everything is as usual. [translation from: 4PDA.ru]
You do not have the required permissions to view the files attached to this post.